🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
AWWA C115 2011

AWWA C115 2011

$75.83

AWWA C115-11: Flanged Ductile Iron Pipe With Ductile-Iron Or Gray-Iron Threaded Flanges

Published By Publication Date Number of Pages
AWWA 2011 36
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This standard describes 3-in. through 64-in. (80 mm through 1600 mm) flanged ductile-iron pipe with ductile-iron or gray-iron threaded flanges for potable water , wastewater, and reclaimed water service. Flanged pipe and flanges are rated for a maximum working pressure of 250 psi (1,720 kPa). However, 24-in. (600 mm) and smaller flanged joints with ductile-iron flanges may be rated for a maximum working pressure of 350 psi (2,413 kPa), as noted in the footnote of Table 1.

PDF Catalog

PDF Pages PDF Title
1 ANSI/AWWA C115/A21.15-11
3 Committee Personnel
7 Contents
9 Foreword
I. Introduction.
11 II. Special Issues.
Table F.1 Gray-iron flange minimum tensile strength
13 III. Use of This Standard.
14 IV. Major Revisions.
15 V. Comments.
17 AWWA Standard Flanged Ductile-Iron Pipe
With Ductile-Iron or Gray-Iron
Threaded Flanges

SECTION 1: GENERAL
Sec. 1.1 Scope
Sec. 1.2 Purpose
Sec. 1.3 Application
18 SECTION 2: REFERENCES
SECTION 3: DEFINITIONS
19 SECTION 4: REQUIREMENTS
Sec. 4.1 Material
20 Sec. 4.2 Pipe Barrel
Table 1 Ductile-iron pipe for use with threaded flanges
21 Sec. 4.3 Flanges
Table 2 Solid gray- or ductile-iron flange dimensions
22 Table 3 Hollow-back ductile-iron flange dimensions
24 Sec. 4.4 Fabrication
Sec. 4.5 Coatings and Linings
25 Sec. 4.6 Marking
SECTION 5: VERIFICATION
Sec. 5.1 Quality Control and Inspection
26 Sec. 5.2 Inspection by Purchaser
Sec. 5.3 Affidavit of Compliance
SECTION 6: DELIVERY
27 APPENDIX A Bolts and Nuts, Gaskets, and Installation

SECTION A.1: BOLTS AND NUTS*
SECTION A.2: GASKETS
28 Table A.1 Flange gasket details
29 SECTION A.3: INSTALLATION
31 APPENDIX B Typical Pipe and Flange Thread Construction
33 APPENDIX C Wall Pipe

SECTION C.1: SERVICE
SECTION C.2: DIMENSIONS
SECTION C.3: MATERIAL AND FABRICATION
SECTION C.4: INSTALLATION
34 Table C.1 Collar dimensions
35 Table C.2 Suggested minimum “face-to-wall” dimensions

Related products

AWWA C115 2011
$75.83