🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
BS EN 50342-1:2015+A2:2021:2022 Edition

BS EN 50342-1:2015+A2:2021:2022 Edition

$142.49

Lead-acid starter batteries – General requirements and methods of test

Published By Publication Date Number of Pages
BSI 2022 30
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

TC21X working group 3 has been agree to implement following changes to EN 50342-1:2015/1:2018 – Deletion of high current discharge after water consumption test. This is not needed as a dedicated corrosion test is available in the document. – Limitation of the maximum discharge time in cranking performance test. Batteries with high power capability might be damaged if discharge until the cut off voltage of 6,0 V is reached. To prevent this the maximum discharge time of the second step of the cranking performance test has been limited to 180 s.

PDF Catalog

PDF Pages PDF Title
2 undefined
6 1 Scope
2 Normative references
3 General
3.1 Introduction
7 3.2 Designation of starter batteries
3.3 Condition on delivery
3.3.1 Specific gravity of electrolyte and open circuit voltage
3.3.2 Definition of fully charged new battery
8 3.4 Electrical characteristics
3.5 Mechanical characteristics
9 4 General requirements
4.1 Identification, labelling
4.2 Marking of the polarity
5 General test conditions
5.1 Sampling of batteries
10 5.2 Charging method – Definition of a fully-charged battery
5.3 Test equipment
5.3.1 Measuring instruments
11 5.3.2 Water bath
5.4 Test sequence
12 6 Test methods and requirements
6.1 Capacity check Ce
13 6.2 Cranking performance test
14 6.3 High current discharge test at low temperature
6.4 Charge acceptance test
15 6.5 Charge retention test
6.6 Endurance in cycle test
16 6.7 Corrosion test
17 6.8 Deep discharge test
6.9 Water consumption test
18 6.10 Vibration resistance test
20 6.11 Electrolyte retention test
6.11.1 Vented batteries
6.11.2 Valve regulated batteries
7 Dry-charged batteries
7.1 General
21 7.2 Activation of dry charged batteries
7.3 Testing of dry charged batteries
22 Annex A (normative)!Safety labelling — Definition of the six coloured safety signs"
24 Annex B (normative)Correlation between C20 and RC
25 Annex C (normative)Battery performance marking
28 European foreword
29 1 Modification to Table 3, “Test sequence”
2 Modifications to Clause 6, “Test methods and requirements”

Related products

BS EN 50342-1:2015+A2:2021
$142.49