BS EN 60384-26:2010
$167.15
Fixed capacitors for use in electronic equipment – Sectional specification. Fixed aluminium electrolytic capacitors with conductive polymer solid electrolyte
| Published By | Publication Date | Number of Pages |
| BSI | 2010 | 36 |
This part of IEC 60384 is applicable to aluminium electrolytic capacitors with conductive polymer solid electrolyte primarily intended for d.c. applications for use in electronic equipment.
NOTE Aluminium electrolytic capacitors with solid (MnO2) are covered by IEC 60384-4 and IEC 60384-4-2. Surface mount aluminium electrolytic capacitors with conductive polymer solid electrolyte are covered by IEC 60384-25 and IEC 60384-25-1.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 9 | 1 General 1.1 Scope 1.2 Object 1.3 Normative references |
| 10 | 1.4 Information to be given in a detail specification |
| 11 | 1.5 Terms and definitions 1.6 Marking |
| 12 | 2 Preferred rating and characteristics 2.1 Preferred characteristics 2.2 Preferred values of ratings Tables Table 1 – Surge voltage |
| 13 | 3 Quality assessment procedures 3.1 Primary stage of manufacture 3.2 Structurally similar components 3.3 Declaration of conformity (basic requirements) 3.4 Test schedule and requirement for initial assessment (mandatory and optional tests) |
| 15 | Table 2 – Fixed sample size test plan for qualification approval, assessment level EZ |
| 16 | Table 3 – Test schedule for qualification approval |
| 21 | 3.5 Quality conformance inspection |
| 23 | Table 4 – Test plan for lot-by-lot inspection (Assessment level EZ) |
| 24 | 4 Test and measurement procedures 4.1 Pre-conditioning (if required) 4.2 Measuring conditions Table 5 – Test plan for periodic inspection (Assessment level EZ) |
| 25 | 4.3 Visual examination and check of dimensions 4.4 Electrical tests |
| 26 | 4.5 Robustness of terminations 4.6 Resistance to soldering heat |
| 27 | 4.7 Solderability 4.8 Rapid change of temperature 4.9 Vibration |
| 28 | 4.10 Shock 4.11 Bump |
| 29 | 4.12 Climatic sequence 4.13 Damp heat, steady state 4.14 Endurance |
| 30 | 4.15 Surge 4.16 Reverse voltage (if required by the detail specification) |
| 31 | 4.17 Component solvent resistance (if required by the detail specification) 4.18 Solvent resistance of the marking (if required by the detail specification) 4.19 Storage at high temperature 4.20 Characteristics at high and low temperature |
| 32 | 4.21 Charge and discharge (if required by the detail specification) 4.22 High surge current (if required by the detail specification) |
| 33 | Bibliography |
