Shopping Cart

No products in the cart.

BS EN IEC 60704-2-16:2019

$142.49

Household and similar electrical appliances. Test code for the determination of airborne acoustical noise – Particular requirements for washer-dryers

Published By Publication Date Number of Pages
BSI 2019 26
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

IEC 60704-2-16:2019 applies to single-unit electric washer-dryers for household and similar use intended for placing on the floor against a wall, for building-in or placing under a counter, a kitchen worktop or under a sink, for wall-mounting or on a counter. This standard is concerned with objective methods of engineering accuracy for determining sound power levels of airborne acoustical noise. Requirements for the declaration of noise emission values are not within the scope of this document. This part is intended to be used in conjunction with IEC 60704-1:2010.

PDF Catalog

PDF Pages PDF Title
2 National foreword
5 Annex ZA(normative)Normative references to international publicationswith their corresponding European publications
7 English
CONTENTS
9 FOREWORD
11 INTRODUCTION
12 1 Scope and object
1.1 Scope
1.1.1 General
1.1.2 Types of noise
1.1.3 Size of the source
1.2 Object
1.3 Measurement uncertainty
Tables
Table 101 – Standard deviations of sound power levels of washing and spinning final results for washer-dryer
13 1.101 Standard deviation for declaration and verification
2 Normative references
3 Terms and definitions
Table 102 – Standard deviations of sound power levels of drying final results for washer-dryer
Table 103 – Standard deviations for declaration and verification for washing and spinning final results for washer-dryer
Table 104 – Standard deviations for declaration for drying final results for washer-dryer
15 4 Measurement methods and acoustical environments
4.2 Direct method
4.3 Comparison method
16 5 Instrumentation
5.3 Instrumentation for measuring operating conditions
6 Operation and location of appliances under test
6.1 Equipping and pre-conditioning of appliances
6.2 Supply of electric energy and of water or gas
17 6.4 Loading and operating of appliances during tests
6.5 Location and mounting of appliances
6.101 Standard test programme for noise measurements
6.101.1 Standard test programme for a washing cycle
6.101.2 Standard test programme for a drying cycle
18 6.101.3 Standard test programme for continuous cycle
6.102 Standard test load for noise measurements
6.102.1 General
19 6.102.2 Pre-treatment of new cotton test load items prior to use
6.102.3 Normalisation of cotton test load items
6.102.4 Conditioning of cotton test load
6.102.5 Standard test load for washing cycle noise measurements
6.102.6 Standard test load for drying cycle noise measurements
20 6.102.7 Standard test load for continuous cycle noise measurements
7 Measurement of sound power levels
7.1 Microphone array, measurement surface and RSS location for essentially free-field conditions over reflecting plane(s)
7.4 Measurements
21 8 Calculation of sound pressure and sound power levels
8.101 Final result
8.101.1 General
8.101.2 Washing final result
8.101.3 Drying final result
8.101.4 Spinning final result when no thermal spin period occurs
22 8.101.5 Spinning final result when thermal spin period occurs
9 Information to be recorded
9.2 Description of appliance under test
9.7 Electric supply, water supply, etc.
9.9 Operation of the appliance under test
23 9.12 Measured data
9.12.101 Spin speed
10 Information to be reported
10.3 Test conditions for the appliance
10.4 Acoustical data
10.4.101 Spin speed at highest noise level
10.4.102 Maximum spin speed
24 Annex A(normative)
25 Bibliography
BS EN IEC 60704-2-16:2019
$142.49