BS ISO 3228:2013
$142.49
Rolling bearings. Cast and pressed housings for insert bearings. Boundary dimensions and tolerances
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 26 |
This International Standard specifies boundary dimensions and tolerances for cast and pressed housings for insert bearings for which boundary dimensions are given in ISO 9628[1].
It applies to plummer block housings, flanged housings and take-up housings.
The inclusion of relubrication features is optional, but when provided it is intended that they intersect the zone specified in ISO 9628[1] in such a way that lubricant satisfactorily feeds from the housing through this zone. The exact design of the relubrication features is not otherwise covered by this International Standard.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_4 Section sec_4.1 1 Scope 2 Normative references 3 Terms and definitions 4 Symbols 4.1 General |
| 8 | Section sec_4.2 Section sec_4.3 Section sec_4.4 4.2 Cast plummer block housing 4.3 Cast flanged housing, square 4.4 Cast flanged housing, oval |
| 9 | Section sec_4.5 Section sec_4.6 4.5 Cast take-up housing 4.6 Pressed plummer block housing |
| 10 | Section sec_4.7 Section sec_5 Section sec_5.1 Section sec_5.2 4.7 Pressed flanged housings, round, triangular and oval 5 Boundary dimensions and tolerances 5.1 General 5.2 Cast housings |
| 11 | Figure fig_1 Table tab_1 |
| 12 | Table tab_2 |
| 13 | Figure fig_2 Table tab_3 |
| 14 | Table tab_4 |
| 15 | Figure fig_3 |
| 16 | Table tab_5 |
| 17 | Table tab_6 |
| 18 | Figure fig_4 Table tab_7 |
| 19 | Table tab_8 |
| 20 | Section sec_5.3 Figure fig_5 Table tab_9 5.3 Pressed housings |
| 21 | Table tab_g Figure fig_6 Table tab_10 |
| 22 | Reference ref_1 Bibliography |
