Shopping Cart

No products in the cart.

AWWA C229 2008

$75.83

AWWA C229-08: Fusion-Bonded Polyethylene Coating For The Exterior Of Steel Water Pipelines

Published By Publication Date Number of Pages
AWWA 2008 28
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Materials and application requirements for factory-applied, fuision-bonded polyethylene coating used on the exterior of steel water pipels and fittings and the joint region of rubber-gasket field-jointed steel water pipes and fittings.

PDF Catalog

PDF Pages PDF Title
1 ANSI/AWWA C229-08
3 Committee Personnel
7 Contents
9 Foreword
I. Introduction.
10 II. Special Issues.
11 III. Use of This Standard.
IV. Major Revisions.
V. Comments.
13 AWWA Standard Fusion-Bonded Polyethylene Coating
for the Exterior of Steel Water Pipelines

SECTION 1: GENERAL
Sec. 1.1 Scope
Sec. 1.2 Purpose
14 Sec. 1.3 Application
SECTION 2: REFERENCES
15 SECTION 3: DEFINITIONS
16 SECTION 4: REQUIREMENTS
Sec. 4.1 Equipment
Sec. 4.2 Materials and Workmanship
Sec. 4.3 Laboratory Qualification Tests for the Polyethylene Material and Coating
Table 1 Properties of polyethylene material
17 Table 2 Properties of laboratory applied coating
Sec. 4.4 Coating Application
19 Sec. 4.5 Coating Steel Pipe Fittings and Specials
Table 3 Properties of production coating
20 Sec. 4.6 Coating Repair
Sec. 4.7 Field Procedures
21 SECTION 5: VERIFICATION
Sec. 5.1 Coating-Materials Acceptance Testing
22 Sec. 5.2 Inspection and Testing by the Purchaser
Sec. 5.3 Laboratory Qualification Tests
24 Sec. 5.4 Coating Production Tests
25 SECTION 6: DELIVERY
Sec. 6.1 Packaging and Marking of Polyethylene Material
Sec. 6.2 Pipe Handling, Transport, and Storage
26 Sec. 6.3 Affidavit of Compliance
AWWA C229 2008
$75.83